Alarm Box, Cylinder Filling

This alarm box is designed to notify the cylinder filling operator to check for leaks at 1000 psi with an amber light; then with an audible alarm and red light at 2000 psi when the fill is nearly...

Back Plate Assembly, DPD

Back Plate assembly for DPD Drive End.  Includes: 0955-4575 9613 SPRING CLIP 2 0955-4670 22693-1 COVER 1 0955-4576 99001-145 WASHER,...

Bakeout Oven Covers, Set of 3

Heat resistant canvas style Bakeout covers 12 Cylinder Bakeout, Set of 3 16 Cylinder Bakeout, Set of 4 21 Cylinder Bakeout, Set of 4 4 cylinder capacity, SS tube reinforced Individual...

Bushing, W50

Clip, Piston Seal Retainer

This clip will attach to an existing W50 Tower and hold the piston seal from dislodging

Cold End Assembly, CV 1.0", Long Poppet Discharge

Complete New Cold End Assembly for most horizontal cryogenic pumps (1.0" Piston).  Clean for oxygen service.  Comes with plate gasket and installation instructions. Includes the following...

Cold End Assembly, Horizontal 1.0" Piston

Complete New Cold End Assembly for most horizontal cryogenic pumps (1.0" Piston).  Clean for oxygen service.  Comes with plate gasket and installation instructions. Includes the following...

Cold End Assembly, Horizontal 1.2" Piston

Complete new Cold End Assembly for most horizontal cryogenic pumps (piston 1.2"), cleaned for oxygen service.  Comes with suction plate gasket and installation instructions. Includes the...

Connecting Rod

Con-Rod, common on most horizontal pumps, CV, LXR, NDPD, DPD, WDPD, SDPD, etc., clean for oxygen service Reference Numbers: 20969-1 740021256

Connecting Rod, P2K and PD3000

Connecting Rod for Either P2K or PD3000 and PD2000 pumps. Reference #  51-2533-30863 or 56434-1

Conversion Conrod - WDPD to DPD

Conversion Conrod - WDPD to DPD - This conrod will allow you to use standard DPD, NDPD, SDPD, CV, LXR Conrod and needle bearings as well as wristpin and crosshead on the WDPD model drive end.

Coupler - 11/16" Pushrod

Coupler, SS,  for 11/16" Pushrod to connet to the Crosshead, comes with nylok set screw, oxygen clean, commonly used on Cryochem P1700 and P1800, Woodland / CryoVation models WCP 27, 36 and 45